Pier Masters

Piering or piling is actually a manner of driving steel pilings for correcting foundation settlement and rectifying building foundations. If you are looking to accomplish foundation repair Kansas City then please read on.

Push piers comprise of parts of epoxy-coated or galvanized steel pipe driven in the ground utilizing a hydraulic ram.

Helical piers use screw piles who have steel shafts. With one or several helixes attached, the lead section offers the necessary bearing capacity. A hydraulic torque motor is used for screwing the piers in to the ground.

With both systems, one or multiple steel piers are driven into a suitable soil bearing layer or rock and are connected by way of a metal head foundation to the foundation. Upon reaching suitable bearing stratum, each pile will then be tested to some greater force than required to keep the structure.

Hydraulic jacks that adhere to embedded steel piers can be used for raising the building blocks straight back to the initial elevation. Following the structure is restored to its desired elevation the piles are then affixed using welds and bolts to wall brackets thus securing the structure’s new elevation.

Advantages Of Piers On Concrete Foundations

-Inexpensive

-The device is portable and can be operated easily in tight spaces with poor access

-No loss in using the dwelling or perhaps disruption

-No heavy equipment

-No destruction of the yard

-Remedies the reason behind the settlement as well as the consequences in just one sweep

Piering Installation

STEPS

1. Adjacent to the building blocks, a 3’ x 4’ excavation is made, which can be approximately 10” below the grade beam.

2. In the footing bottom, soil is scrapped then the foundation chipped smooth for ensuring proper fitting of your support bracket.

3. Hydraulics and brackets are installed then a guide sleeve is advanced with the support bracket.

4. Pier and starter sections are advanced to refusal. The normal penetrating power is 50,000 pounds of total power.

5. The ultimate pier section is cut higher than the support bracket approximately 5” then the fasting plate is attached to the pier column’s top.

6. Hydraulics are reconnected and sequentially operated to improve the structure.

7. After raising the dwelling to desired height, fastening plates and support bracket are affixed to the pier column permanently.

8. When the structure is secure, elevation, pressure, and depth readings are taken for each pier.

9. Excavated soil is replaced and compacted.

10. Concrete and shrubbery removed for installing of the pier is replaced.

Concrete Push Piers

Hydraulic Foundation Repair Piers

Push piers are pier systems driven hydraulically that comprise of sections of epoxy-coated or galvanized steel pipe. The piers bear a point as well as a hydraulic ram is used to drive them through unstable soils to rock bearing strata.

Each pier will then be load tested individually then a patented uniform technique is utilized to stabilize the dwelling and be sure maximum practical recovery. For a hydraulic ram driven piering system, it is assumed that equal bearing strata has become reached when the jacking loads is equivalent to the capability in the steel pier.

Just like the Helical Pier system, this system is proven to assist structures successfully in almost all soil conditions. In addition, it can be used for foundation stabilization and slabs built on questionable soil as well as tieback anchoring, seismic protection, deadman anchoring and fixture anchoring. It could be installed successfully in tight areas.

As you now determine what is involved in Kansas City foundation repair, all you need to do is look for experienced professionals to do the project.